kaoccna 的优势

GB0-283English 试题的质量和价值
mcsepass 模拟测试题具有最高的专业技术含量，只供具有相关专业知识的专家和学者学习和研究之用。
100% 保证您通过 GB0-283English 的考试
如果你使用 mcsepass 模拟测试，我们将保证你的第一次参加考试即取得成功，否则，我们将全额退款！
试用后再购买
mcsepass 提供每种产品免费测试。在您决定购买之前，请检测联接，可能存在的问题及试题质量和适用性。
kaoccna认证考试题库网专业提供 H3C GB0-283English 最新题库下载，完全覆盖 mcsepass 考试原题。

部分考题展示

　
　
Exam : HuaWei GB0-283English
Title : Constructing Enterprise-level Routing Networks


1. CAR is realized at the IP layer so that it can only limit the traffic of IP packets. Compared with CAR, LR can limit all the traffic passing through the physical interface.
A. True
B. False
Answer: A

2. Which of the following descriptions about QoS at the access, convergence and core layers is/are correct? ( )
A. QoS is implemented identically in the access, convergence and core layers.
B. Packets are classified and marked in the access layer.
C. No QoS mechanism should be configured in the access layer.
D. Usually, the queuing mechanism (such as CBQ) and the congestion avoidance mechanism (such as WRED) should be used in the convergence layer.
Answer: BD

3. As shown in the figure, Area 1 is an NSSA area and RouterD is the ABR of the area. The configuration on RouterD is as follows:
ospf 1
area 0.0.0.1
network 10.45.0.0 0.0.0.255
nssa default-route-advertise
#
area 0.0.0.0
network 4.4.4.4 0.0.0.0
network 10.34.0.0 0.0.0.255
Which of the following descriptions about the above network diagram and configuration is correct? ( )
A. RouterD redistributes a Type 7 LSA for a default route in Area 1. RouterE and RouterF can receive this LSA.
B. RouterD redistributes a Type 5 LSA for a default route in Area 1. RouterE and RouterF can receive this LSA.
C. RouterC can receive a Type 5 LSA for a default route redistributed by RouterD.
D. None of the above
Answer: A

4. Which of the following descriptions about OSPF STUB area is wrong? ( )
A. A backbone area cannot be configured as STUB area and a virtual link cannot pass through a STUB area.
B. It is unnecessary to configure this attribute on all routers in a STUB area.
C. There is no ASBR in a STUB area.
D. After an area is configured as STUB area, the Type 3 LSA of other areas can be propagated in this area.
Answer: B

5. The multicast address used by OSPF is ( ).
A. 224.0.0.5
B. 224.0.0.6
C. 224.0.0.9
D. 224.0.0.10
Answer: AB

6. When a BGP Speaker advertises the imported IGP routes to the IBGP neighbor, the AS-Path value is the local AS number.
A. True
B. False
Answer: B

7. The BGP mandatory attributes include ( ).
A. Origin
B. AS-Path
C. Next-hop
D. MED
E. Local-preference
F. Community
Answer: ABC

8. Which of the following descriptions about the IPSec Security Association (SA) is/are correct? ( )
A. The data security service provided by IPSec is realized through SAs.
B. One SA is a unidirectional logical connection between two IPSec peers.
C. The inbound data flow and outbound data flow are respectively processed by the inbound SA and outbound SA.
D. SAs can be set up by the means of manual configuration or automatic negotiation.
Answer: ABCD

9. Which of the following descriptions about route aggregation in OSPF is/are wrong? ( )
A. The ABR can automatically summarize routes without manual configuration.
B. Aggregation can be made only on the ABR.
C. The router serving as the ABR and the ASBR concurrently cannot summarize routes.
D. The ASBR can summarize all external routes.
Answer: ABCD

10. A BGP router receives a new route from its EBGP peer, which of the following descriptions is correct? ( )
A. The router will immediately send the route to its BGP peers.
B. The router will look up this route in its routing table. If the route is not recorded in the routing table, it will send the route to its BGP peers.
C. The router will check the sent routes information. If it never sends such a route, it will send the route to its BGP peers.
D. The router will check the sent routes information. If it has sent such a route, it will not send the route to its BGP peers.
Answer: C

11. Which of the following descriptions about BGP route aggregation is/are correct? ( )
A. Route aggregation is to aggregate routes of all segments into one or more aggregation routes so as to reduce the size of routing table.
B. If the keyword detail-suppressed is added to the BGP summary command, only the aggregation routes are advertised.
C. BGP route aggregation takes effect on the route imported through the network command only.
D. BGP route aggregation takes effect on the route imported through the import command only.
Answer: AB

12. The ASBR imports four external routes, 192.168.0.0/24, 192.168.1.0/24, 192.168.2.0/24 and 192.168.0/24. These routes are aggregated to one route 192.168.0.0/22 by the ABR. Which routes will the ABR redistribute to the other areas? ( )
A. One aggregation route
B. The four original routes
C. One aggregation route and the four original routes
D. None
Answer: B

13. Which of the following descriptions about queue is correct? ( )
A. WFQ discarding mechanism is Tail Drop on each queue, the same as CQ.
B. WFQ classifies data flow by using ACL.
C. CBWFQ is an improvement of WFQ using the same basic scheduling as WFQ.
D. LLQ will first check the low-latency queue and take packets from the queue. Only when there is no packet in the low-delay queue, it will take the packets from other queues. In addition, it uses other mechanisms to avoid starving to death of the queues.
Answer: D

14. Compared with IPv4, the IPv6 address is extended to ( ).
A. 128 bits
B. 164 bits
C. 64 bits
D. 256 bits
Answer: A